For the very small places, cut the foam rubber into small pieces and use the tweezers, again SLIGHTLY DAMPENED, for cleaning. This will clean all water soluble contaminants like soda, coffee, and sugar residue. If they are too wet the excess water will contaminate the keyboard through capillary action. Replace these often and BE SURE they are only slightly damp. CAREFUL, these are small and like to jump away.Ĭlean the keyboard with cotton swabs SLIGHTLY DAMPENED with water. Remove all of these and place in a separate container. There will be a small rubber piece for each key. IMPORTANT: Make a keyboard map so as to remember where each key goes.Ĭarefully pry each key loose with a small screwdriver and place in a container.

This is a PTFE (Teflon) based lubricant which dries perfectly DRY and is ideally suited for this application.

Super Lube Dry Film spray (critical - DO NOT SUBSTITUTE!) available in the automotive section.

Household cleaner, Windex or equivalent.

Cosmetic foam rubber cleaning pads (use only with lighter fluid, NOT alcohol).

This will require about 2 hours time once the proper cleaning materials are collected. The following will completely solve these problems and return the keyboard to perfect operation. There are several reasons why the keys will start to stick - spilled drinks, wearing off of factory lubrication, weakening of the rubber pieces which give each key its snap action, and contamination by dust and hair. Proper cleaning and lubrication as described here will restore a ZPC-GX31 keyboard to the snappy and smooth performance it had when new. This process will restore a ZPC-GX31 keyboard to like new performance. Trying anything suggested here or anywhere on the web is always at one's own risk. It is provided as a courtesy, and no warranty is expressed or implied. Do NOT follow this procedure for the ZPC-D5. The following information is recommended for advanced users only, and ONLY APPLIES TO THE FOLLOWING CYBERNET MODELS: ZPC-9000, ZPC-9100 and ZPC-GX31. Please note: this video does not go in to complex cleaning issues – if you have a specific question that was not answered in the video, please leave us a comment and we’ll provide you with a more specific answer.Cause - Keys have become soiled/dirty over time, causing them to stick and/or not snap back properly Replace they keys and you’re good to go!Īs part of our Electronics Cleaning Essentials, we’ll show you the proper, basic way to clean and maintain a keyboard. Use a cleaning toothbrush to remove the debris and build up and clean the keys with a microfiber cloth using that 50/50 mix. Use a flat object to wedge gently underneath the key and it should pop right off.

Not only is the build up gross (see video) but it can cause sticky or malfunctioning keys. Yes, this does take a bit of time but it is worth it. Remember to always spray away from the electronic!Ībout once a year, pop the keys off the keyboard one by one to expose the base of the keyboard and to give yourself the opportunity to clean each button individually. Finally, lightly mist a cotton swab with the 50/50 mix and use it to get in between keys to remove any final debris or stains.Try to get rid of any oily marks, drips and fingerprints. Rub the cloth up and down the board and keys and use a circular motion to buff out any stubborn spots. After that, lightly spray a microfiber cloth with a 50/50 mix of rubbing alcohol and water.Don’t shake the can, and always hold it upright. Then, use a can of compressed air to blast out any stuck debris make sure to use quick blasts.Start at the top and brush your way to the bottom. Use the cleaning toothbrush to brush debris out of the keyboard. Start by turning off the keyboard (or unplug it) and hold it upright.Items you’ll need: Compressed air, cotton swabs, cleaning toothbrush, rubbing alcohol, water, and a microfiber cloth. Some people may wonder, how do I disinfect a keyboard? Because we have the ability to use rubbing alcohol knowing it won’t harm the keyboard, we use a 50/50 mix of rubbing alcohol and water to disinfect the keys.

We’ve looked at the manufacturer’s instructions to determine the safest and most effective way to clean a standard keyboard and this is how it’s done. Last updated: ApWondering the proper way to clean your keyboard?

Sticky key keyboard cleaner spray